APC AXFA11G user manual Parameters, Parameter Lists, Parameter Description

6. PARAMETER DESCRIPTION

6.PARAMETER DESCRIPTION

6.1 Parameters

With the exception of parameters that were specified by the customer upon ordering, all of the AXFA11’s internal parameters will initially be set to default values. Actions such as the modification of display details can then be carried out whenever necessary.

IMPORTANT

Make sure to keep the AXFA11’s power on at least for 30 seconds after you set the param- eters. If you turn the power off immediately after the parameters are set, the settings will be canceled.

NOTE

In order to ensure that correct flow rate data can be acquired, it is crucial that the nominal size, flow rate span, and meter factor of the combined remote flowtube are setup. In cases where a remote flowtube is ordered at the same time as the AXFA11, the nominal size and meter factor will be setup upon shipment from the manufac- turing plant, and these will not require additional setting. If the AXFA11 is ordered individually, the default value will be setup for the meter factor; accordingly, it will be necessary to change this setting to the meter factor indicated on your remote flowtube data plate.

If a flow rate span is specified upon ordering, this will be set before shipment. If this is not the case, however, it will be necessary for the appropriate value to be set up by the user.

6.2 Parameter Lists

Parameter lists are comprised of the following items.

Item	Name	R/W	Data	Units	Position of	Default	Description
			range		decimal point	value
								Describes the parameter content.
								The default value (as setup upon plant shipment).
								If marked “(*)”, it indicates that the appropriate
								setting has been made in accordance with
								ordering information and data for a remote
								flowtube to be combined.
								The position of the decimal point within the data
								range and also the allowed relocation range in
								terms of places of decimals.
								The units corresponding to the data range.
								This item defines the range of data to be set for
								numeric parameters and also defines selection of
								data for selection-type parameters.
								R: Read only
								W: Writable
								The name of the parameter. Entries in parentheses
								indicate the parameter name displayed on the
								handheld BRAIN Terminal (BT200).
								Parameter number.
									T0601.EPS

6-1 IM 01E20C01-01E