4-
Section 4 - Lubrication & Maintenance
Inspection Access
Inspection Access
Engine Access
In order to perform service, inspection and lubrication operations to the tractor, it may be necessary to open or remove various panels and shields..
IMPORTANT: After performing work on the tractor, | 1 | |
install all safety shields before operating the tractor. | ||
|
Battery Access
The batteries are located on top of the right side fuel tank.. Release the latch (1) and lift the battery cover..
Make sure the cover is down and latched when | ||
operating the tractor.. | ||
| ||
|
Opening the Hood Panels
To provide easy access to the engine, each hood side panel swings open vertically.. There is an external latch,
(2)that releases the panel.. Each panel is held open by a single gas strut.. Close the hood panels by pulling downward from the side of it and keeping a steady pressure on the panel.. The gas strut will collapse and the panel will go over center and latch.. Do not force the panel down against the gas strut..
Removing the Hood Panels
The hood panels can be easily removed if greater access is required for maintenance or service operations..
1.Remove the hairpin clips (3) from the front and rear pivot studs retaining the hood panel hinge plates..
2.Disconnect the gas strut from the hood panel..
3.Slide the panel forward to clear the pivot studs and lift clear..
4.Set the panel clear of the working area to prevent damage..
To reinstall the panels, reverse the above procedure..
2
3
435/485/535