4-60

Section 4 - Lubrication & Maintenance

As Required

Operation 83

Change the Ether Canister

The cold start solenoid is mounted on the left side of rear hood support..

Remove the protective yellow cap (1) or unscrew the empty ether canister anti-clockwise from the top of the solenoid valve (2), making sure that the gasket remains in place.. Lubricate the gasket with a light film of clean oil..

Remove the protective cap from the new ether canister..

1

2

F4-93

Lower the ether canister (3) into the top of the solenoid valve (2) and screw it in clockwise..

Tighten the ether canister hand tight only..

Once the ether canister is screwed into the solenoid valve, secure the canister firmly by attaching the clamp (4) around the canister.. Tighten the clamp..

NOTE: The ether bottle is not shipped as standard equipment from the factory and should be sourced locally.

CAUTION: STARTING FLUID IS HIGHLY FLAMMABLE. DO NOT USE NEAR FIRE, SPARKS, OR FLAMES. BE SURE ALL OPERATORS READ THE CAUTIONARY INFORMATION ON THE CANISTER.

CAUTION: THE ETHYL ETHER USED AS COLD START FLUID IS EXTREMELY FLAMMABLE, TOXIC, AND FATAL IF SWALLOWED. AVOID CONTACT WITH EYES OR SKIN. AVOID BREATHING THE FUMES.

IF SWALLOWED, DO NOT INDUCE VOMITING. CALL DOCTOR IMMEDIATELY.

IF COLD START FLUID ENTERS EYES OR FUMES IRRITATE EYES, WASH EYES WITH LARGE QUANTITIES OF CLEAN WATER FOR 15 MINUTES. CONTACT A DOCTOR, PREFERABLY AN EYE SPECIALIST, IMMEDIATELY.

3

4

2

F4-94

435/485/535