3-34

Section 3 - Operation

Electronic Instrument Cluster - EIC

Selectable Display

Using the key pad, the lower display will allow the operator to select one of following displays:

Ground Speed Display (Speedometer)

The Ground speed (5) and the MPH or km/h legend

(6)will be displayed when the tractor is moving.. Switching between MPH or km/h is covered within EIC programming in this section.. When the display is set to another mode the ground speed may be recalled at any time by touching the GROUND SPEED button (7)..

NOTE: The speedometer senses rotation of the rear axle and may be subject to errors caused by the effects of wheel slip, tire pressures/condition, etc. If the optional radar sensor is installed, the tractor senses true ground speed for greater measurement accuracy.

NOTE: The lower central display will automatically show ground speed if the tractor is traveling at more than 20 km/h (12.4 MPH ).

Engine Hour Meter

When the KEY-START switch is turned on, the LCD will display the hours the engine has operated (8) and the hour meter symbol (9)..

Driving the tractor will cause the display to change automatically to ground speed.. The hour meter display may be recalled at any time by touching ENGINE HOUR button (10)..

With the engine running, the hour meter will accumulate hours in increments of 0.1 hours until 1999..9 hours are reached.. After that time, the hour meter will accumulate complete hours only, e..g.. 2000, 2001 hours, etc..

NOTE: Accumulated hours are stored in the computer permanent memory which is not affected by disconnecting the tractor batteries.

The hour meter may be programmed to remind the operator when the next scheduled service is due..

Service Alert

When a Service Alert is reached, the word “SERVICE”

(11)will flash along with the selected display.. See “Setting the service alert intervals” on page 3-41..

56

F3-43

7

11

9 8

F3-46

10

435/485/535