3-23 Section 3 - Operation

Cab Controls & Instruments

Trouble Light (Optional)

A trouble light is located in the left, rear corner of the cab, under the rear deck.. The light has a 5..5 M (18') power cord attached.. To remove the light

(1)move the locking lever (2) to the left and carefully pull the light downward while unwinding the cable from the holder.. The light base is magnetic which enables attachment to the tractor for convenience while working..

The light switch (3) is a two-position switch.. With the switch lever in the off position (vertical), the light is off.. With the switch lever in the on position (horizontal), the light will come on when the cab door is open..

The trouble light, when it is stowed in it’s cradle, is used in conjunction with the cab dome lights to illuminate the cab interior when the cab door is open..

NOTE: The trouble light has been designed to turn off when the door is closed.

To stow the trouble light, reel in the cable with the crank handle (4) inserting the pin (5) into its socket, and lock in position with the lever (2)..

4

 

2

3

 

1

5

F3-27

Power Outlets

Three power outlets are located in the rear deck behind the operator’s seat..

Outlet (6), 12 volt, 1-pin accessory connector.. Outlet (7), 12 volt, 3-pin accessory connection.. Outlet (8), 16-pin diagnostic connector..

Outlet (9), Cummins diagnostic connector.. Outlet (10), CAT TA22 transmission diagnostic connector (Optional CAT TA22 Installation only)

NOTE: On earlier models a Cummins engine diagnostic

cable, BVI p/n: 86033779 is supplied with the tractor and is located in the storage tray under the seat. This cable connects to the 16 pin connector (8) and the Cummins insite tool harness.

The 3-pin accessory plug (7) has 3 terminals..

Pin 1 - Key switched 12 volt power source protected by a 20-amp fuse..

Pin 2 - Live 12 volt power source protected by a 20-amp fuse..

Pin 3 - Ground..

10 9 8 7 6

F3-25

1

2

 

3

F3-26

435/485/535