Section 3 - Operation
Electronic Instrument Cluster - EIC
In the event of an engine fault occurring, 1 of 3 warning lamps will flash depending on the level of the fault..
4. Engine Maintenance - Attention (white lamp)
Illuminates when engine maintenance is required.. A fault code is also displayed..
5. Engine Maintenance - Warning (yellow lamp)
Illuminates when a
6. Engine Maintenance - Critical (red lamp)
Illuminates when a critical fault occurs in the electronic engine control system.. The alarm will sound and the engine “STOP” message will flash in the center display for 30 seconds before automatic engine shut down occurs.. The cause of the malfunction should be located and corrected immediately to prevent damage to the tractor..
7. Air Filter Restriction
The Air Filter lamp will illuminate accompanied by the
8. Cold Start
The Cold Start lamp will illuminate when outside temperature is at or below 0° C (32° F)..
Use the ether cold start to assist engine starting in cold weather, (see page
9. Coolant Level Low
The Coolant Level lamp will illuminate when coolant drops below the sender level.. A critical alarm will sound.. Check for leaks and refill cooling system..
10. Alternator Charge Indicator
The Alternator lamp will illuminate steady if the alternator is not charging the battery.. The lamp will flash and the
11. Intercooler Overheated
The Intercooler lamp will illuminate and the non- critical alarm will sound when an overheat condition occurs.. The cause of the alarm should be determined and corrected before further operation or engine damage may occur..
4 | 5 | 6 | 7 |
|
|
|
|
8 | 9 | 10 | 11 |
|
|
|
