Section 3 - Operation
Articulation Blocks
Articulation Blocks
Each individual tire size requires a specific articulation block to be used with that tire size..
Refer to the table opposite for the maximum articulation angle allowed based on tire selection..
There are three possible articulation angles used on the tractor.. They are 42°, 38° & 33°.. The following information shows what each articulation block configuration looks like.. The articulation block mounting plates are located on either side of the front frame adjacent to the fuel tanks..
IMPORTANT: Install the proper articulation blocks on the tractor before the dual or triple wheels are installed on the unit to prevent any accidental damage from occurring.
NOTE: Any tractor that is equipped with a PTO option requires a 38° articulation block kit be installed on it. If the tire size of the tractor requires a 33° articulation kit, use those kits instead of the 38° kit for a PTO option.
WARNING: IMPROPER ASSEMBLY OF THE ARTICULATION BLOCKS CAN CAUSE THE TRACTOR WHEELS TO CONTACT THE FUEL TANK WHEN TURNING. MAKE SURE THE ARTICULATION ANGLE IS WITHIN LIMITS.
42° - The maximum turning angle allowed by the steering cylinders is 42°.. If your tractor tire size allows an angle of 42°, no articulation blocks are required..
435/485/535