Buhler 485, 535, 435 manual Entering Fault Codes Mode, Viewing Fault Codes, To Exit Mode

3-40

Section 3 - Operation

EIC - Tractor Performance Monitor (TPM)

Fault Codes

In the event that a fault occurs within the tractor electrical circuits, a malfunction warning symbol “READ YOUR MANUAL,” (1) will flash on and off and the code will be stored.. The tractor is factory set to display normal TPM functions and to store fault codes..

To view fault codes as they occur, see “Turning active fault display on/off” on page 3-42

Fault codes (2) will be displayed as flashing three- digit number preceded by the letter “F..”

The fault code indicates the tractor circuit or sensor in which the fault lies and the type of fault, e..g.., short circuit, open circuit, sensor failure, etc..

A complete detailed list of fault codes, their cause and remedy may be seen in “Section 5 - Troubleshooting Charts..

If necessary, contact your Buhler Versatile authorized dealer and quote the fault code number..

Entering Fault Codes (Mode 2)

1.Hold the SELECT button (3) for two seconds

2.The TPM will display “1” (4) and “CAL (5)..” Use the UP/DOWN arrows (6) to change the display (4) to “2”

3.Hold the SELECT button (3) for two seconds to enter into Mode 2 (Fault Codes)

Viewing Fault Codes

Touch the LEFT/RIGHT arrow buttons (7) to cycle through stored fault codes.. Each fault code will be displayed along with the number of times the fault has occurred, the engine hours of the most recent occurrence, and the position of the fault code in the stored list..

The illustration, F3-137 shows a typical fault code display..

8 - Fault Code, 9 - Item number, 10 - Number of occurrences, 11 - Engine hours of the last occurrence..

To Exit Mode 2

Touch the START/STOP (8) button to return to the calibration menu.. Touch the START/STOP button (8) again to return to normal operation..

			AREA	PTO RPM
			DISTANCE	START
				STOP
1	2			SELECT
	SPEED	% SLIP
				F3-61
				8
			AREA	PTO RPM
	4	6	DISTANCE	START
				STOP
	5	CAL		SELECT
	SPEED	% SLIP
			7	3
				F3-122
10				9
	11		8	F3-137

435/485/535