Buhler 485, 535, 435 manual Lubricate the Front Drag Link Pins

4-17 Section 4 - Lubrication & Maintenance

Every 10 Hours or Daily

Operation 15

Lubricate the Front Drag Link Pins

Lubricate the grease fittings (one on each side) (1) until grease flows from around the pin seals.. This will purge any dirt accumulated in the pivot pin area..

Use Moly base grease (NLGI 1 Lithium, Moly)..

1 F4-22

Operation 16

Lubricate the Rear Drag Link Pins

Lubricate the top two grease fittings (2) remotely mounted on the left rear frame, until grease flows from around the pin seals.. This will purge any dirt accumulated in the pivot pin area..

Use Moly base grease (NLGI 1 Lithium, Moly)..

Operation 17

Lubricate the Rear Axle Drive Shaft Steady Bearing

Lubricate the grease fitting (3) until grease flows from the bearing area.. This will purge any dirt accumulated in this area..

Use Moly base grease (NLGI 1 Lithium, Moly)..

2

F4-21

3

F4-23

435/485/535