Section 1 - Safety Safety Labels
ROLL OVER PROTECTIVE STRUCTURE
FOR TRACTORS: 435/485/535
PROTECTIVE STRUCTURE
PART NO: 86031286
MEETS OSHA REGULATION
CERTIFIED TO CSA STANDARD
86033283
1. ROPS Certificate - Located left underside of cab.
2.
CAUTION
ATTACH IMPLEMENTS PROPERLY
• Attaching clevis type tongues
• Attaching clevis type tongues
•Pull only from drawbar or three point hitch.
•Use a safety chain when towing implement.
5.Implement Attaching - Located above the drawbar at the rear of the tractor.
WARNING
CONTENTS UNDER PRESSURE
Accumulator charged to 69 bar (1000 psi).
Pump service brakes at least ten times with engine off to release pressure before loosening any fittings connected to the accumulator.
86034047
6.Accumulator Pressure - Located on the fender support above the multifunction valve.
86001239
WARNING
ENGAGE PARK BRAKE BEFORE EXITING TRACTOR
86034142
WARNING
AVOID POSSIBLE
INJURY OR DEATH
Do not start engine by shorting across starter terminals. Engine can start and machine can move when starting safety switch is
Start engine only from operator’s seat with transmission in neutral and the parking brake applied
3. Tie down brackets | 4. Park Brake - Located | 7. Jump starting - Located on the left |
- Located on frames. | inside cab on right hand window | side frame next to the starter. |
CAUTION
•DO NOT CONNECT JUMPER CABLE TO NEGATIVE POST OF DISCHARGE BATTERY
•DO NOT LEAN OVER BATTERIES WHILE MAKING CONNECTIONS
•DO ENSURE POSITIVE AND NEGATIVE CLAMOS ARE NOT IN CONTACT
•DO ENSURE VEHICLES ARE NOT IN CONTACT
BATTERY BOOST INSTRUCTIONS
• Apply parkbrake, set transmission in neutral and turn all electrical connections off
• Connect one end of jumper cable to positive terminal of boosting battery and other end to positive terminal of discharged battery
Connect one end of negative cable to negative post of battery and other end to |
|
• tractor frame at least 300 mm (12") from discharged battery | |
|
8.Battery Boosting - Located on the underside of the battery cover.
