4-59 Section 4 - Lubrication & Maintenance

As Required

Operation 79

Check the Windshield Washer Fluid

The front and (rear-optional) windscreen washers are

1

fed from a single reservoir located behind the right

 

hand fuel tank..

 

Remove the lid (1) on the reservoir and add fluid as

 

necessary..

 

F4-91

Operation 80

Change the Windshield Wiper Blades

The front and rear windshield wiper blades can be changed using the following procedure:

Pivot the wiper arm outward away from the window.. Remove the blade bolt (2) from the center of the blade.. Install the new blade and reinstall the center bolt..

The front and rear windshield wiper blade is 713 mm (28") long..

Replacement wiper blade (front & rear)

P/N: 86032440

Operation 81

Clean the Cab Floor

Keep the cab floor free of dirt and debris that may cause an obstruction or safety hazard, especially around the brake and clutch pedal area..

The cab floor should be kept clean by periodically vacuuming or sweeping, and washing..

The floor mat can be removed from the cab floor by rolling it away from the walls of the cab and pulling it upward and away from the floor.. The floor mat is a two-piece rubber mat that can be washed using a mild detergent..

2

F4-92

Operation 82

Clean the Cab Seat and Upholstery

When the soft trim material and seat become dirty, they should be wiped clean.. Dip a cloth in a warm water/detergent solution and wring out as much of the water as possible.. Wipe the interior material with the damp cloth..

The interior molding inside the cab can be cleaned with a water/detergent solution as needed..

435/485/535