Electro-Hydraulic Remote Control Valves

Remote control valves are available to operate external hydraulic cylinders, motors, etc.. The valves are located at the rear of the tractor..

Tractors with a standard hydraulic system can be equipped with four or six remote control valves..

Tractors with a high flow hydraulic system can be equipped with six or eight remote control valves..

NOTE: The total system flow is not available to operate any one single hydraulic circuit. The maximum available flow from any one remote valve is 95 ± 8 L/min (25 GPM± 2 GPM).

Electro-Hydraulic (EHR) Control Pods

The EHR valves are operated by finger controlled levers located in the Control Pods (1) (two valves per pod)..

Each control lever is identified by a color coded decal

(6)which corresponds with it’s color coded remote valve..

The remote valve control levers have four positions: neutral, extend, retract and float..

Pull the lever back from the neutral position (2) to the “extend” (raise) position (3).. From neutral, push forward to the “retract” (lower) position (4).. Push the lever fully forward to the float position (5)..

3-83 Section 3 - Operation

Hydraulic Operation - Electro-hydraulic

F3-119

1

ON

N

N

N

N

 

N

N

 

 

 

F3-108

2

3

6

4

5

F3-105

435/485/535