4-

Section 4 - Lubrication & Maintenance

General Information

General Information

Introduction

This section gives full details of the service procedures necessary to maintain your tractor at peak efficiency.. The Lubrication and Maintenance Chart provides a ready reference to these requirements.. Each operation is numbered for easy reference..

In addition to the regular maintenance operations listed, check the following items every 10 hours or daily during the first 50 hours of operation:

•Wheel hardware for tightness..

•Planetary hub and differential oil level

•Check for leaks, loose or damaged parts..

IMPORTANT: Park the tractor on level ground and, where applicable, extend all cylinders before checking oil levels.

Preventing System Contamination

To prevent contamination when changing oils, filters, etc.., always clean the area around the filler caps, level plugs, drain plugs, dipsticks and filters prior to removal.. Before connecting remote cylinders, ensure that oil contained within them is clean, has not degenerated due to long storage, and is of the correct grade..

To prevent dirt entry during greasing, wipe dirt from the grease fittings before greasing.. Wipe excess grease from the fitting after greasing..

Flexible Maintenance Intervals

The intervals listed in the Lubrication and Maintenance Chart are guidelines to be used when operating in normal working conditions..

Adjust the intervals for environmental and working conditions.. Intervals should be shortened under adverse (wet, muddy, sandy, extremely dusty) working conditions..

Safety Precautions

Read and observe all safety precautions listed in Section 1, “Safety: Servicing The Tractor..”

NOTE: Dispose of used filters and fluids properly. Consult local officials for proper procedures.

Lubrication and Maintenance Chart

The chart lists the intervals when routine checks, lubrication, service and/or adjustments should be performed.. Use the chart as a quick reference guide when servicing the tractor.. (The operations follow the chart)..

CAUTION: DO NOT CHECK, LUBRICATE, SERVICE OR ADJUST THE TRACTOR WITH THE ENGINE RUNNING.

First 50–Hour Service

At the first 50–hour service, ensure that the maintenance operations listed on the “First 50–Hour Service” checklist, located at the back of this manual, are carried out..

IMPORTANT: Items listed in the first 50–hour check are important. If not performed, early component failure and reduced tractor life may result.

435/485/535