Section 4 - Lubrication & Maintenance
Every 10 Hours or Daily
Operation 9
Check the Transmission Oil Level
When checking the transmission oil, ensure the following:
•Check the oil level with the tractor parked on a level surface with the engine shut off..
•With cold oil, the oil level should show in the sight glass section designated as cold.. Add oil if necessary to bring the oil level to the bottom of the cold section of the sight glass..
•With hot oil, the oil level should show in the sight glass section designated as hot.. Add oil if necessary to bring the oil level to the bottom of the hot section of the sight glass..
Synchromesh Transmission
The oil level for the Synchromesh transmission is easily checked by looking at the sight gauge (1) located on the rear lower left corner of the transmission case..
The sight gauge has an “ADD” and “FULL” line indicated on it.. If additional transmission oil is required, remove the cap (2) from the filler tube and add oil as necessary..
1407 Twindisc Powershift Transmission
The oil level for the 1407 Twindisc Powershift transmission is checked by looking at the sight gauge located on the rear lower left corner of the transmission case (3).. If additional transmission oil is required, remove the cap (4) from the filler tube and add oil as necessary..
CAT TA22 Powershift Transmission
The oil level for the CAT TA22 Powershift transmission is checked by looking at the sight gauge located on the rear lower right corner of the transmission case (5).. If additional transmission oil is required, remove the cap (6) from the filler tube and add oil as necessary..
NOTE: Do not operate the transmission with oil levels above or below the recommended settings. Either condition can result in overheating or loss of power and damage to the equipment.
1 |
|
2 |
Synchromesh Transmission
4 |
3 |
|
1407 Twindisc Powershift Transmission
6 |
5 |
