3-

Section 3 - Operation

Cab Features - Seating

Standard Seat

The seat is equipped with controls to permit the following adjustments for personal comfort..

NOTE: All adjustments should be made in the following order while sitting in the seat.

Adjust the seat using the following procedures:

NOTE: With the engine off, adjust the seat by turning the ignition switch to the “ACC” position.

DO NOT START THE ENGINE.

1. Height/Weight Adjustment

Raise - Depress the top of the switch.. Release when the desired height is obtained..

Lower - Depress the bottom of the switch.. Release when the desired height is achieved..

2. Backrest Angle Adjustment

Lift the lever and tilt the backrest to the desired position.. Release the lever to lock the backrest in position..

NOTE: The backrest will tilt backward far enough to contact the rear window.

3. Fore/Aft Position Adjustment

1

2

4

3

5 6

F3-5

6.Storage tray Pull out for access..

Pull up on the lever and move the seat fore/aft through the 178 mm (7”) adjustment range to the desired position.. Release the lever to lock the seat into position..

4. Fore/Aft Float

Pull up on the lever to allow the seat to float fore and aft 51 mm (2”).. Push down on the lever to lock the seat into position..

5. Lateral Float

Pull up on the lever to allow the seat to float laterally 51 mm (2”).. Push down on the lever to lock the seat into position..

435/485/535