
Section 4 - Lubrication & Maintenance
Every 250 Hours
Every 250 Hours
Operation 24
Change the Engine Oil and Filter
To change the engine oil and filter, operate the engine until the coolant temperature reaches 60° C (140° F).. Shut off the engine..
There are two oil plugs (3) located on the bottom of the oil pan.. Either plug can be removed to drain the oil.. Drain the oil completely to make sure all the oil and suspended contaminates are removed from the engine..
NOTE: All model tractors use one single oil filter mounted on the
Clean the area around the oil filter head (4).. Unscrew the old filter (5) and discard..
Clean the sealing surface of the filter head.. The
NOTE: Fill the new filter with clean engine oil. (The lack of lubrication during the delay until the filter is charged with oil is harmful to the engine).. Apply a light film of oil to the gasket sealing surface before installing the new filter..
Install the new filter on the filter head.. Tighten the filter until the gasket contacts the filter head surface.. Tighten the filter an additional 1/2 to 3/4 of a turn..
NOTE:
Clean and check the oil drain plug threads and the sealing surface.. Install and tighten the oil drain plug..
3 |
4 | 5 | |
|
Torque Value: 47 N·m (35
Wrench size: 3/4"
Fill the engine with high quality
NOTE: The engine is filled with
Operate the engine at idle speed and inspect for leaks at the filters and drain plugs..
NOTE: Engine oil pressure must be indicated on the EIC display within 10 seconds after starting. If oil pressure is not registered within 10 seconds, shut off the engine immediately to avoid engine damage. Confirm the correct oil level in the oil pan.
Shut off the engine.. Wait approximately five minutes to let the oil drain from the upper parts of the engine.. Check the oil level again..
Add oil as necessary to bring the oil level to the (FULL) mark on the dipstick..
IMPORTANT: Discard used engine oil according to local laws and regulations.