2-

Section 2 - General Information Transporting

Transporting the Tractor

1.Haul the tractor with all four wheels on to a flatbed trailer..

2.Remove the outer duals or triples during transporting unless special permits allow for over- width hauling.. Consult local authorities for information on over-width hauling..

3.Make an accurate measurement of the highest point on the tractor when it is loaded on the transporter.. Consult local authorities regarding over-height hauling based on the measurements taken..

4.Tie-down brackets are located in the following positions..

Cutout slots (1) are located on either side of the front frame to allow a chain hook to be used to hold down the front end of the tractor..

Tie-down brackets are located on either side of the rear frame, in the articulation area (2) and on the drawbar cage (3).. Use a chain of adequate size, routed through the brackets to hold down the tractor..

6.Always fully engage the park brake and install the articulation lock pin (4) when transporting the vehicle..

4

F1-6

1

2

3

F2-14

435/485/535