Buhler 535, 485, 435 manual AD-7

3-44

Section 3 - Operation

EIC - Calibration

Entering Wheel speed calibration (Mode 20)

A 100 meter (328 ft) track is required to perform wheel speed calibration.

1.Drive tractor to the start of the designated test area..

2.Stop the tractor 10 m before the start line..

3.Press and hold the SELECT button (1) on the Tractor Performance Monitor (TPM) display for 2 seconds until TPM displays “1”..

4.Touch the UP arrow button (2) until the TPM displays “20”..

5.Press and hold the SELECT button (1) on the TPM for 2 seconds until TPM displays “DIST CAL 0”..

6.Select a low gear and drive the tractor forward..

7.As the tractor crosses the “Start Line” touch the SELECT button (1) once.. The TPM will display “DIST CAL 1”

8.Continue driving until the tractor reaches the “Finish Line”..

	AREA	PTO RPM
	DISTANCE	START
		STOP
	CAL	SELECT
SPEED	% SLIP	1
		AD-7
	AREA	PTO RPM
	DISTANCE	START
		STOP
		SELECT
SPEED	% SLIP	2
		AD-8
	AREA	PTO RPM
	DISTANCE	START
		STOP
OFF
DIST	CAL	SELECT
SPEED	% SLIP	1
		AD-9
	AREA	PTO RPM
	DISTANCE	START
ON
		STOP
DIST	CAL	SELECT
SPEED	% SLIP	1
		AD-10

435/485/535