
Right Side Console Controls
Remote Hydraulic Valve Control -
Each lever (3) activates a four position remote electro- hydraulic valve.. From neutral pull the lever rearward to the stop for raise.. Push forward one position at a time for neutral, lower and float..
Each lever is color coded for identification with the remote valve it controls..
Note: See “Remote
Electro-hydraulic Engagement Switch (gray)
Depressing button (1) in the center of the engagement switch (2) while pulling upwards on the knob will engage the
Pushing the knob down will disengage the electro- hydraulic controls and all hydraulic flow to the rear remote valves..
IMPORTANT: The remote valve
1 | 2 | 3 | 4 |
ON |
|
|
|
N | N | N |
|
|
| ||
N |
|
|
|
|
|
| N |
| 5 |
| |
|
|
|
Remote Valve Electro-hydraulic Flow Control Knobs
Each remote valve has a flow control knob (4) to meter oil flow.. The knob controls flow from 4 to 102 L/MIN (1 to 27 GPM).. Turn the knob so the higher vertical decal stripe is visible to increase the rate of oil flow.. Turn the knob so the lower vertical decal stripe is visible to decrease the rate of oil flow.. See page
Remote Valve
Each remote valve has a manual/programmable operation switch (5).. When the top of the switch is activated the lever (3) operates in the manual mode.. When the bottom of the switch is activated the lever
(3)can be operated with a programmed release to neutral.. See page