Buhler 535 Operation Electronic Instrument Cluster EIC Fuel Level, Battery Volts, Central Display

3-32

Section 3 - Operation

Electronic Instrument Cluster - EIC

Fuel Level

The inside right bar graph (3) indicates fuel level.. Each segment of the bar graph display represents one-twentieth (approximately 5 percent) of the total fuel content of the tank..

When the fuel level falls so that only two segments of the bar graph are displayed, the bar graph will flash continually and the non-critical alarm will sound for one second..

The system also has a feature to assist the operator during refueling procedures.. An audible indicator alerts the operator when the tanks are filled to 3/4 capacity (15 bars) and 19/20 or 95% (19 bars)..

NOTE: This feature only operates when the ignition switch is set to the “RUN” position.

CAUTION: ALWAYS SHUT THE ENGINE OFF DURING REFUELING PROCEDURES

Battery Volts

The outside right bar graph (4) indicates battery voltage..

Central Display

Three liquid crystal displays (LCD) are located in the center of the instrument cluster..

5.The top LCD is the digital transmission gear shift position display..

6.The center LCD is the digital engine speed display..

7.The lower LCD will display selected information as follows:

•Tractor ground speed (MPH or km/h)

•PTO speed (rev/min)

•Engine hours accumulated (actual time)

•Service alert - as required

•Timed exit - as required

3 4

F3-39

5

6

7

F3-40

435/485/535