3-26

Section 3 - Operation

Electronic Instrument Cluster - EIC

Audible Alarm

An audible alarm will sound under the following conditions:

•when the ignition is first switched on..

•when a warning light illuminates or a bar graph indicates a malfunction..

The alarm will alert the operator that a malfunction has occurred..

Depending on the severity of the malfunction, the alarm will sound as follows:

Non-Critical Alarm - An audible alarm sounds for one second only.. The tractor will continue to operate, but the cause of the alarm should be investigated and corrected..

Critical Alarm - A continuous pulsating tone will sound until the malfunction is corrected or the engine is switched off.. The engine “STOP” message will flash in the center display for 30 seconds before automatic engine shut down occurs.. The cause of the malfunction should be located and corrected immediately to prevent damage to the tractor..

The audible alarm has a rotary volume control (1) located on the left side of the steering column below the front controls.. Rotate the alarm cover to adjust the volume..

n/min RPM

F3-30

1

F3-31

Automatic Engine Shut Down

An automatic engine shut down feature is standard equipment.. This feature will automatically shut down the engine within 30 seconds under the following conditions:

•Transmission oil pressure low

•Engine oil pressure low

•Intake manifold temperature high-critical

•Engine coolant temperature high-critical

•Engine coolant level low

•Electrical charging system voltage low

•Engine oil temperature high-critical

WARNING: The engine shut down feature is fully automatic. It can be overridden by the operator to drive the tractor to a safe location. The override switch is to the right of the steering column and should only be used to move the tractor far enough to avoid a dangerous situation.

(See “Engine Shut down Override Switch Operation” page 3-18)..

435/485/535