Extreme Networks 17001 manual Sliding the Switch onto the Rear Mounting Brackets

3From the back of the equipment rack, slide the switch into place over the mounting brackets (see Figure 98). Make sure the brackets slide between the support pegs on both sides of the switch.

Figure 98: Sliding the Switch onto the Rear Mounting Brackets

SH_126

4Push the switch forward as far as it will go, until the bracket support pegs are against the T of the mounting bracket (Figure 99).

Securely tighten the rack mounting screws.

Figure 99: Fastening the Rear Mounting Brackets

SH_128

Summit Family Switches Hardware Installation Guide 129