Extreme Networks 17001 manual Replacing a Summit X480/X650 Fan Module

Maintenance Procedures for Summit X650 and Summit X480 Series Switches

Replacing a Summit X480/X650 Fan Module

The procedure for replacing a fan module is the same for either a Summit X480 series switch or a Summit X650 series switch.

You need the following tools and equipment to replace a Summit X480/X650 series fan module:

●ESD-preventive wrist strap

●1/2-inch flat-blade screwdriver

CAUTION

Be sure to finish the replacement procedure promptly. The switch may overheat if it is left without cooling for an extended period.

To replace the fan module:

1Completely loosen the captive retaining screws at the lower corners of the fan module (Figure 178).

2Slide the fan module out of the switch and set it aside.

Figure 178: Removing a Fan Module (Summit X650 Series Switch Shown)

SH_090

3Carefully slide the replacement fan module into the switch (Figure 179).

Figure 179: Installing a Fan Module (Summit X650 Series Switch Shown)

SH_091

4Align and fully tighten the captive retaining screws.

210 Summit Family Switches Hardware Installation Guide