Extreme Networks 17001 manual Removing a Summit X650 Series Switch, Removing the Power Supplies

Installing Summit Family Switches

Figure 140: Connecting the DC Power Cables (Part 2)

RTN -48V

(+)

(–)

SH_112

6Connect the cables to the DC source voltage, using hardware appropriate to the installation site and following local and national electrical codes.

7Energize the DC circuit.

Leave the ESD strap permanently connected to the rack, so that the strap is always available when you need to handle ESD-sensitive components.

Removing a Summit X650 Series Switch

This section provides procedures for removing a Summit X650 series switch from a two-post or four-post equipment rack.

Removing the Power Supplies

Before you remove a Summit X650 series switch from the rack, remove all installed power supplies, as described in this section.

164 Summit Family Switches Hardware Installation Guide