Extreme Networks 17001 manual Rack-mounting an EPS-500 Power Supply, Attaching a Mounting Bracket

NOTE

An AC power cord is not provided with the EPS-500 unit. See “Selecting Power Supply Cords” on page 218 for information about selecting a power cord.

Rack-mounting an EPS-500 Power Supply

CAUTION

When installing an EPS-500 in a rack system, make sure that the air vents are not restricted. Allow for elevated ambient operating temperatures when the unit is installed adjacent to other equipment. To avoid hazardous conditions due to uneven mechanical loading, make sure that the equipment is mounted properly in the rack system.

Do not use the rack-mount brackets to suspend the EPS-500 from under a table or desk, or to attach the unit to a wall.

To rack-mount each EPS-500:

1Place the EPS-500 upright on a stable surface, with the side you want to face to the front of the switch toward you.

2Remove the mounting bracket kit from the packaging.

3Attach the mounting brackets as follows:

a Place a mounting bracket over the mounting holes on one side of the EPS-500 (see Figure 153). b Insert the provided screws and fully tighten the screws using a screwdriver.

Figure 153: Attaching a Mounting Bracket

Collin's

ES4K026

XM_073

cRepeat steps a and b on the opposite side of the EPS-500.

4Slide the EPS-500 into a 19-inch rack and secure it using appropriate rack-mount screws.I

NOTE

Extreme Networks recommends that you position the EPS-500 so that the output connectors are on the same side as the external connector on the connecting switch. If you position the EPS-500 with the connectors facing in the opposite direction from the Summit switch connector, leave at least 1 u between the switch and the EPS- 500 through which to slide the power cords. Do not route the power cords around the equipment rack.

Summit Family Switches Hardware Installation Guide 181