Extreme Networks 17001 manual Attaching a Rear Mounting Bracket-Two-Post Rack Installation

Figure 124: Attaching a Rear Mounting Bracket—Two-Post Rack Installation

SH_097

3From the back of the equipment rack, slide the switch into place over the mounting brackets (see Figure 125). Make sure the brackets slide between the support pegs on both sides of the switch.

Figure 125: Sliding the Switch onto the Rear Mounting Brackets

SH_082

4Push the switch forward as far as it will go, until the bracket support pegs are against the T of the mounting bracket (Figure 126).

Securely tighten the rack mounting screws.

Summit Family Switches Hardware Installation Guide 151