Extreme Networks 17001 manual Installing a Summit X650 AC Power Supply, Removing a Blank Panel

Installing a Summit X650 AC Power Supply

CAUTION

Make sure that the AC PSU circuit is not overloaded. Use proper over-current protection, such as a circuit-breaker, to prevent over-current conditions.

To install a Summit X650 AC PSU:

1Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate grounding point.

2If necessary, remove a blank panel from the back of the Summit X650 series switch (Figure 133).

Figure 133: Removing a Blank Panel

SH_088

3Verify that the PSU is right side up, with the latching tab at the right of the unit (see Figure 134).

4Carefully slide the PSU all the way into the power supply bay (see Figure 134). Push the PSU in until the latch snaps into place.

CAUTION

Do not slam the PSU into the switch.

Summit Family Switches Hardware Installation Guide 157