Extreme Networks 17001 manual Installing the Power Supply, Attaching a Terminal to a Cable

Installing Summit Family Switches

Figure 110: Attaching a Terminal to a Cable

SH_109

Installing the Power Supply

To install a Summit X480 DC PSU:

1Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate ground point on the rack.

2If necessary, remove a blank panel from the back of the Summit X480 series switch (Figure 111).

Figure 111: Removing a Blank Panel

SH_157

3Verify that the PSU is right side up (see Figure 112).

4Carefully slide the PSU all the way into the power supply bay (see Figure 112). Push the PSU in until the latch snaps into place.

CAUTION

Do not slam the PSU into the switch.

138 Summit Family Switches Hardware Installation Guide