FLOPPY DISK DRIVE

For directions on installing a floppy disk drive see To Install or Remove a Device in Multi-function Bay 1, page 100. In addition an optional external floppy disk drive may be purchased and installed (page 103) for use when Multi-function Bay 1 is needed for other uses. (For information on the care and use of floppy disk drives see Floppy Disk Drive in Section Two on pages 34–36.)

C A U T I O N

The floppy disk drive must be installed or removed with the power off, unless you are swapping it in Multi-function Bay 1 with the optional battery.

U s e r I n s t a l l a b l e F e a t u r e s

Figure 4-5 Floppy Disk Drive

To install a floppy disk drive externally, you must purchase an optional external floppy disk drive.

To Connect An Optional

External Floppy Disk Drive:

1.Close all files and exit all applications.

2.Turn off power to your notebook, close the display and remove the AC adapter. (See pages 24–25 for more information.)

L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u

3.Open the external floppy disk drive port cover on the left side panel of your notebook (Figure 4-6), by gently pulling on the front edge of the cover and swinging it toward the back of your notebook.

4.Align the external floppy disk drive cable with the smaller connector towards the body of your notebook with the wide side of the connector down. (Figure 4-6.)

5.Insert the connector firmly into the port on your notebook until it clicks.

6.Insert the other cable connector into the back of the external floppy disk drive and press firmly until it clicks.

121

Page 131
Image 131
Fujitsu 990TX2 manual To Connect An Optional External Floppy Disk Drive