Fujitsu 990TX2 manual LANdock To install your notebook in a LANdock

LANdock

To install your notebook in a LANdock:

1.Put your notebook in Suspend mode or turn off the power.

2.To use a docking device with your notebook they both must be on a flat surface.

3.Remove all connections from the rear panel of your notebook. (See Figure 1-7 on page 8.)

4.Make sure that the adjustment feet are flat against the bottom of the notebook and the covers of the connectors, both rear panel and right side panel,are closed.

5.Make sure that the slide cover in the rear panel is completely open.

6.Set your notebook on the leveler, making sure that the alignment pins on the leveler (Figures 4-17 and 4-19)fit into the Docking Alignment receptacles in the bottom of your notebook. (Figure 1-8 on page 10.)

L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u

U s e r I n s t a l l a b l e F e a t u r e s

7. Arrange the notebook/leveler combination to align the docking connector on the docking device body with the Docking port on your notebook and the notches on the leveler with the notches on the docking device body. (Figure 4-16.)

8. Push together firmly.

9. Lock in place by pulling the Docking Release lever forward.

10. Verify that docking is complete by checking that the LifeBook Docked LED is illuminated. (Figure 4-17.)

11. Return your notebook to operation using

the Suspend/Resume button or power switch,as appropriate. (When setting up the LANdock for the first time you must use the power switch.)

Figure 4-16 Installing Your Notebook

in a Docking Device

139