Symptom

The CD-ROM Access indicator on the Status Indicator panel blinks at regular intervals when no CD is in the tray or the CD-ROM drive is not installed.

T r o u b l e s h o o t i n g

Possible Cause

5.Setup utility is set to something other than CD-ROM for the Secondary Master Controller.

6.Wrong drive designator was used for CD-ROM in the application.

7.Windows CD auto insertion function is disabled.

1.The Windows CD auto insertion function is active and is checking to see if a CD

is ready to run.

L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u

Possible Solution

5.Revise BIOS settings to set the Secondary Master correctly. (See Main menu and Secondary Master submenu pages 60–61 for more information.)

6.Verify the drive designator used by the application is the same as the one used by the operating system. When the operating system is booted from a CD-ROM drive designations are automatically adjusted. (See Boot Options submenu on page 106.)

7.Start the CD from the desktop or applica- tion software or re-enable the Windows CD auto insertion function. (See CD-ROM Drive Access Indicator on pages 21–22 for more information.)

1.This is normal. You can disable this function if you wish. (See CD-ROM Drive Access Indicator on pages 21–22 for

more information.)

149

Page 159
Image 159
Fujitsu 990TX2 manual Symptom, Possible Cause, Possible Solution