Honeywell K5404V9 manual Events, To set an alarm on the events tab, Alarm doubling

Alarms and Events

Multi-Media unit back to the state that it was in, before the two “applies”. For an illustration of these buttons in the Maintenance window, see figure 62 on p.6–13.

6.7.2Events

!87 To set an alarm on the events tab

1.Continue or start a maintenance session. To start a session, see 6.7.1: Maintenance Session.

2.Click the Events tab. Select a sub-tab, as needed. The sub-tabs on the Events tab list Session events, System events, and so on—each with its own Log check box and Alarm check box.

3.Add a checkmark to the Alarm check box next to the event that you want to set as an alarm.

4.Repeat steps 3 and 4 for other events, as needed.

5.Click Apply. From now on, should these events occur, an alarm is triggered in View.

6.You have the option of ending the maintenance session.

Alarm doubling

When a Multi-Media unit has been setup to call back an alarm station, and you happen to be running an alarm session at the alarm station, an event at the site triggers a call and an alarm.

Fig. 62. Using maintenance to set events to report an alarm.

6–13