Current Calibration Status Register
The Current Calibration Status Register provides a
Address | Bit | 15 | 14 | 13 | 12 | 11 | 10 | 09 | 08 | 07 | 06 | 05 | 04 | 03 | 02 | 01 | 00 | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
READ | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | Ch | ||
Base + 18616 | ||||||||||||||||||
| 16 | 15 | 14 | 13 | 12 | 11 | 10 | 09 | 08 | 07 | 06 | 05 | 04 | 03 | 02 | 01 | ||
| WRITE | |||||||||||||||||
| Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | Curr | ||
|
| Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | Cal | |
|
| Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | Stat | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Ch XX Curr Cal Stat: This field is set to a one (1) when the channel has been successfully current calibrated. This field is set to a zero (0) when the channel is not current calibrated.
Notes This register is not set or used by the hardware. The HP E1418A SCPI driver, if used to calibrate the module, automatically sets the bits in this register. If you use register programming to calibrate this module, you may wish to use this register to record the calibration status.
The Voltage Calibration Status Register, the Current Calibration Status Register, the Calibration Isolation Status Register, and the Calibration Card Configuration Register are used together to store the overall calibration status of the module.
Appendix B | HP E1418A |
