HP E1418A manual Chapter Module Setup and Installation

To Remove a Module: To remove a module from a mainframe:

1.Remove any terminal modules.

2.Loosen the top and bottom screws securing the module in the mainframe.

3.Move the extraction levers away from each other. As the levers are moved, the module will detach from the backplane connectors.

4.Slide the module out.

Note The extraction levers will not seat and unseat the backplane connectors on older HP VXIbus mainframes and non-HP mainframes. You must manually seat the connectors by pushing the module into the mainframe until the front panel is flush with the front of the mainframe. The extraction levers may be used to guide or remove the module.

Chapter 1 Module Setup and Installation 21