HP E1418A manual Terminal Module Options, Option A3E Crimp-and-Insert Connector

Terminal Module Options

Besides the standard screw-type terminal module, the HP E1418A can be ordered with the following two options. One option (A3E) provides crimp-and-insert connectors and terminal housing. The other option (A3H) provides a ribbon cable connector and terminal housing.

Option A3E HP E1418A Option A3E can be ordered if a crimp-and-insert terminal module is desired. This allows you to crimp connectors onto wires which are then inserted directly into the HP E1418A faceplate connector. Refer to the pin-out diagram on page 30 to make the connections. The crimp-and-insert connector is shown in Figure 1-10.

Note The pin numbering on the crimp-and-insert connector may not agree with the pin numbering on the HP E1418’s faceplate connector. Use the pin numbering on the faceplate connector to wire the crimp-and-insert connector.

Figure 1-10. Option A3E Crimp-and-Insert Connector

Chapter 1 Module Setup and Installation 27