APPLy

APPLyn:VOLTage

APPLyn:VOLTage <value MIN MAX DEF> outputs a voltage on the specified channel, n.

Parameters

 

Parameter

Parameter

Range of

Default

 

Name

Type

Values

 

 

 

 

 

 

 

APPLyn

keyword

1 to 8 or 1 to 16

1

 

 

 

 

 

 

<value>

numeric (float 32) or

-16 V to +16 V or MIN MAX DEF

0

 

 

discrete

 

 

 

 

 

 

 

Comments In the keyword, APPLyn, the valid range of n is:

 

 

1 to 8 for

E1418A, E1418A Option 002

 

 

1 to 16 for

E1418A Option 001, E1418A Option 003.

 

Values of n outside these ranges will generate an error.

The <value> parameter can range from -16 Volts to +16 Volts. MIN sets -16 Volts output.

MAX sets +16 Volts output. DEF sets 0 Volts output.

This command is affected by the state of the program jumper on the terminal module for this channel. To use the APPLyn:VOLT command:

the P/J jumper must be set to program selectable or, if set to jumper selectable,

the V/I jumper must be set to the voltage mode. This jumper is described on page 31.

Equivalent Commands: SOURcen:FUNCtion:MODE VOLT,

SOURcen:VOLTage[:LEVel][:IMMediate][:AMPLitude], OUTPutn[:STATe] ON

*RST Condition:

If the P/J jumper is set to program selectable:

output mode is set to voltage, 0 volts output, output relay open.

If the P/J jumper is set to jumper selectable:

output mode is set by the V/I jumper, 0 volts or amps, output relay open.

Chapter 3

HP E1418A SCPI Command Reference 65

Page 65
Image 65
HP E1418A manual APPLy APPLynVOLTage