Code | Error Messages | Potential Cause(s) |
|
|
|
|
|
|
+3008 | Invalid Calibration State | An invalid sequence of calibration commands was received. |
|
| For example, a CALn:CONF:VOLT command followed by a |
|
| CALn:VAL:CURR command. |
|
|
|
+3009 | Invalid Calibration Channel | An invalid channel number, n, was requested in the |
|
| CALn:CONF or CALn:VAL commands. |
|
|
|
+3010 | Calibration aborted | A command, other than one of the CALibration commands, was |
|
| received during the calibration process. |
|
|
|
+3011 | Checksum error on Calibration | Calibration constants in RAM are corrupted. Recalibration is |
| Memory | needed. |
|
|
|
+3012 | Channel cannot be programmed to | An attempt to set the channel output mode when the P/J jumper |
| this mode, check jumpers | is set to Jumper selectable and the mode is set by the V/I |
|
| jumper. |
|
|
|
+3013 | Waiting for Trigger | An attempt to change a channel output value or mode was |
|
| made after the trigger system in the |
|
|
|
+3014 | Illegal while initiated | An attempt to program a channel was made when the channel |
|
| is in the |
|
|
|
+3015 | Indicates a hardware failure in | |
|
|
|
|
|
|
Appendix C | HP E1418A Error Messages 152 |
