HP E1418A manual Single-Conductor, Contact

Crimp-and-Insert	The following accessories are necessary for use with crimp-and-insert
Terminal Module	Option A3E:
Accessories
Single-Conductor and	A crimp-and-insert contact is crimped onto one end of a wire. The other
Contact	end is not terminated. Order HP 91510A.

Shielded-Twisted-Pair and A crimp-and-insert contact is crimped onto each conductor at one end of a Contacts shielded-twisted-pair cable. The other end is not terminated. Order

HP 91511A.

Jumper Wire and Contacts A crimp-and-insert contact is crimped onto each end of a single-conductor jumper wire. This jumper is typically used to tie two pins together in a single crimp-and-insert connector. Order HP 91512A.

Crimp-and-Insert Contacts These contacts may be crimped onto a conductor and then inserted into a crimp-and-insert connector. The crimp tool kit is required to crimp the contacts onto a conductor and remove the contact from the connector. Order HP 91515A.

Crimp-and-Insert Tools The hand crimp tool (part number HP 91518A) is used for crimping contacts onto a conductor. The pin extractor tool (part number HP 91519A) is required for removing contacts from the crimp-and-insert connector.

These products are not included with Option A3E or with the terminal option accessories listed earlier.

28 Module Setup and Installation Chapter 1