HP E1418A manual SOURce SOURcenCURRentLEVelTRIGgeredAMPLitude

SOURce

SOURcen:CURRent[:LEVel]:TRIGgered[:AMPLitude]

SOURcen:CURRent[:LEVel]:TRIGgered[:AMPLitude] <value MIN MAX DEF>

outputs the current set in value at channel n when the trigger conditions are satisfied and the output relay is closed. Use this command to synchronize multiple channel outputs.

Parameters

	Parameter	Parameter	Range of	Default
	Name	Type	Values
	SOURcen	keyword	1 to 8 or 1 to 16	1
	<value>	numeric (float 32) or	-0.02 Amps to +0.02 Amps or	0
		discrete	MIN MAX DEF
Comments ∙ In the keyword, SOURcen, the valid range of n is:
	1 to 8 for	E1418A, E1418A Option 002
	1 to 16 for	E1418A Option 001, E1418A Option 003.

Values of n outside these ranges will generate an error.

∙The <value> parameter is a floating point 32-bit number in the range of -0.02 A to +0.02 A.

MIN sets -0.02 Amps. MAX sets +0.02 Amps. DEF sets 0 Amps.

∙This command sets channel n to output the current specified following a valid trigger condition. Following this command, the trigger system must be enabled using an INITiate command. See the TRIGger subsystem discussion on page 54 for additional information.

∙If the module is in a wait-for-trigger state (INIT has been received) when this command is received, an error is generated.

∙The output state of the channel must be enabled and the trigger event satisfied for the current to appear at the output terminals.

∙If the channel is in the voltage mode when this command is received, an error is generated.

∙Related Commands: SOURcen:CURRent[:LEVel]:TRIGgered[:AMPLitude]?, SOURcen:FUNCtion:MODE CURRent, OUTPutn[:STATe]

Chapter 3 HP E1418A SCPI Command Reference 87