HP MSL6000 manual Fsc

Table 10 Fault Symptom Codes (continued)
FSC	Message	ERP
20c0	Drive In Error	•	Press the Enter button to clear the
	(Control failed to set SCSI ID.)		message.
		•	Ensure the drive shows good status
			through the drive status window.
		• Check SCSI ID settings.
		• Cycle power to the library or reboot
			using the GUI touch screen.
20c1	Drive In Error	•	Press the Enter button to clear the
	(Control failed on installed drive.)		message.
		•	Ensure the drive shows good status
			through the drive status window.
		• Check SCSI ID settings.
		•	Check cabling.
		• Cycle power to the library or reboot
			using the GUI touch screen.
3000	Motor Fault Condition	•	Press the Enter button to reboot.
	(One of the robot motors has been	•	Cycle power to the library or reboot
	disabled and could not be re-enabled.)		using the GUI touch screen.
3002	Picker Tach Errors	•	Press the Enter button to reboot.
	(Picker tachometer errors were detected	•	Cycle power to the library or reboot
	when checking slots.)		using the GUI touch screen.
3005	Pass-thru Tach Errors	•	Power down the library using the LCD
	(Excessive Pass through elevator tach		touch display.
		•	Remove Pass-through and check
	errors.)
			connections.
3011	Bin Fetch Failure	•	Press the Enter button to reboot.
	(Loader failed to fetch a cartridge from a	•	Ensure cartridges are fully inserted in the
	bin.)		magazine(s).
		• Ensure that there are no obstructions
			inside the library (all cartridges are in
			magazines).
		• Run the cartridge cycle diagnostic to
			verify.
		• Check the tape cartridge used in the last
			operation for damage.

MSL6000 series tape library user guide 109