Table 6 View SCSI Options
Option | Description |
Drive 0 Bus ID | Lets you set the SCSI addresses of drive 0. The designators |
| Drive 0 (outer tape drive) through Drive n refer to the first |
| through nth drives, counting from right to left starting with |
| the master unit in a scaled Library system. Default is 1. |
|
|
Drive 1 Bus ID | Lets you set the SCSI addresses of drive 1. The designators |
| Drive 1 (inner tape drive) through Drive n refer to the |
| second through nth drives, counting from right to left |
| starting with the master unit in a scaled Library system. |
| Default is 2. |
|
|
Drive 2 Bus ID | Lets you set the SCSI addresses of drive 2. The designators |
Drive 2 (lower, outer tape drive) through Drive n refer to | |
only) | the third through nth drives, counting from right to left |
| starting with the master unit in a scaled Library system. |
| Default is 3. |
|
|
Drive 3 Bus ID | Lets you set the SCSI addresses of drive 3. The designators |
Drive 3 (lower, inner tape drive) through Drive n refer to | |
only) | the fourth through nth drives, counting from right to left |
| starting with the master unit in a scaled Library system. |
| Default is 4. |
|
|
Library SCSI Bus ID | Lets you set the SCSI addresses for the library robotics. The |
| default is 0. |
|
|
Library SCSI Bus Parity | Lets you enable or disable the library robotics SCSI bus |
| parity checking. The default is Enabled. |
|
|
Mail Slot Access | This option controls access to the mail slot and media |
| removal. “Prevent Allow” Command Inhibits allows access |
| to the mail slot via the GUI control panel and allows |
| media removal. “Prevent Allow” Command Ignored |
| prevents access to the mail slot and removal of media. This |
| option is used for some backup applications. The default is |
| “Prevent Allow” Command Inhibits. |
|
|
SCSI Mode | Defines the loader as |
|
|
|
|
Unit Attention | Lets you select reporting of all or only one |
Reporting | attention conditions. If set to Report All, the unit reports all |
| unit attention conditions in sequence; if set to Report One, |
| the unit reports only the highest priority condition. The |
| default is Report All. |
|
|
