Table 10 Fault Symptom Codes (continued) |
|
| |
|
|
| |
FSC | Message | ERP | |
3033 | Chassis S/N did not scan | • Press the Enter button to clear the | |
| (A valid serial number bar code label |
| message. |
| • | Contact support. | |
| could not be read.) | ||
|
|
| |
3034 | Chassis S/N save operation failed | • Press the Enter button to clear the | |
| (The serial number scanned from the bar |
| message. |
| • | Contact support. | |
| code label could not be saved to | ||
|
|
| |
|
|
| |
3035 | Drive Unload Prevented | • Remove the cartridge from the library via | |
| (The drive prevented media removal |
| the Move Media using the LCD touch |
|
| display. | |
| barcode on cartridge in drive could not |
| |
| be read.) | • Inspect/replace the barcode label if | |
|
|
| necessary. |
|
|
| |
3040 | Motor Firmware Error | • Press the Enter button to reboot. | |
| (The loader task detected an unexpected | • Turn off power to the library and inspect | |
| status and could not recover.) |
| connectors and cables. |
|
|
| |
3041 | Loader Received Invalid Command | • Press the Enter button to reboot. | |
| (The loader task received an unexpected | • Turn off power to the library and inspect | |
| command and could not recover.) |
| connectors and cables. |
|
|
| |
3042 | Motor Firmware Error | • Press the Enter button to reboot. | |
| (The loader task detected an unexpected | • Turn off power to the library and inspect | |
| status and could not recover.) |
| connectors and cables. |
|
|
| |
3050 | Missing Magazine | • Press the Enter button to clear the | |
| (In diag, no magazine installed for diag |
| message. |
| • | Insert magazine. | |
| to run.) | ||
|
| • Invalid user initiated operation. Set | |
|
|
| parameters correctly and try again. |
|
|
| |
3051 | No Cartridges In Library | • Press the Enter button to clear the | |
| (No cartridge available for diag to run.) |
| message. |
| • | Insert cartridge. | |
|
| ||
|
| • Invalid user initiated operation. Set | |
|
|
| parameters correctly and try again. |
|
|
| |
3052 | Too Many Cartridges | • Press the Enter button to clear the | |
| (Unable to run cartridge or drive cycle |
| message. |
| • Remove a tape from the library. | ||
| because loader is full with cartridges.) | ||
|
| • Invalid user initiated operation. Set | |
|
|
| parameters correctly and try again. |
|
|
|
|
114 Troubleshooting
