Ethernet Port
The Fibre Channel card has one Ethernet port Z. LED definitions:
•Activity - there is port activity
•Link - a valid Ethernet link exists
Fibre Channel Port
The Fibre Channel card has one Fibre Channel port ]. LED definitions:
•Green (ACT) - Fibre Channel port activity [
•Green (LINK) - a valid Fibre Channel link exists \
SCSI VHDCI Connectors
The Fibre Channel card has two SCSI VHDCI connectors. A green LED indicates activity on the corresponding port.
Configuration
For detailed configuration information, refer to the HP StorageWorks Network Storage Router User Guide available on the MSL Series tape library documentation CD, or on the HP website at: http://www.hp.com/support.
Before attempting to configure the Fibre Channel board, a basic understanding of Fibre Channel and SCSI devices is recommended. For information on SCSI standards, refer to publications from X3T10 committee of ANSI (American National Standards Institute). For more information on Fibre Channel standards, refer to publications from the X3T11 committee of ANSI. To purchase approved American National Standards and Technical Reports, contact ANSI at
Default Ethernet Settings
The basic factory default values are:
•IP address: http://1.1.1.1/
•Subnet mask: 255.255.255.0
•Gateway address: 0.0.0.0
•User name: root
•Password: password
HP recommends that you change these values from the defaults.
All settings within the configuration are
After changing the basic default values listed above, carefully consider any additional configuration changes.
After the initial configuration is established, HP recommends backing up the configuration to an external file via the FTP file transfer protocol option. If needed, during a recovery process, this file can be restored back onto the router.
