HP MSL6000 manual Fsc

Table 10 Fault Symptom Codes (continued)
FSC	Message	ERP
305B	Diag Fetch, Drive not loaded	•	Press the Enter button to clear the
	(Diag: no cartridge present for fetch.)		message.
		•	Load a cartridge in the drive and retry
			the operation.
		• Invalid user initiated operation. Set
			parameters correctly and try again.
305D	Diag Timeout waiting for drive empty,	•	Press the Enter button to reboot.
	ready	•	Invalid user initiated operation. Set
	(Fetch, time-out waiting for drive unload.)		parameters correctly and try again.
		• Ensure the drive shows good status
			through the drive status window.
		• Check the tape cartridge used in the last
			operation for damage.
305F	Invalid bin number	•	Press the Enter button to clear the
	(Invalid bin number detected in diag.)		message.
		•	Invalid user initiated operation. Set
			parameters correctly and try again.
3060	Zone Sequence Error	•	Cycle power to the library or reboot
	(Robot did not find sensor on power-up.)		using the GUI touch screen.
3074	Drive 0 Eject Failed	•	Press the Enter button to reboot.
	(Eject command time-out.)	•	Ensure the drive shows good status
			through the drive status window.
		• Deactivate the drive using the GUI control
			panel maintenance menu.
		•	Reseat drive.
		• Load/unload a cartridge to the drive to
			verify.
		• Check the tape cartridge used in the last
			operation for damage.
		• Run the cartridge cycle diagnostic to
			verify.

116 Troubleshooting