HP R4.2 bus, card, System Control, 3 Voice System Administration

3 Voice System Administration System Control

Table 6 describes the fields in this window.

Table 6. Field Descriptions for Diagnose Equipment Window

Field	Description
Equipment to	Specifies whether the type of equipment to be diagnosed is a circuit card or
diagnose:	a bus. Enter card or bus, or press F2 (Choices) to select from a menu.
	There is no default value for this field. This is a required field.
Equipment	A number that identifies each E1/T1, LSPS, or SSP circuit card. Equipment
number:	numbers are defined by the position of the circuit card in the circuit card
	table shown on the Display Voice Equipment window (Figure 61 on page
	96). Card range can be from 1 to 16. When you specify a range of circuit
	cards, cards are diagnosed in order, one at a time. This is a required field.
	The bus value must be 1.
Immediate	Specifies whether there should be immediate diagnosis on the selected
diagnosis?:	circuit card. Type y for yes, n for no, or press F2 (Choices) to select from a
	menu. If you choose yes, all calls on active channels for the specified
	equipment are terminated. If there are active calls and you choose no, the
	circuit card is returned to the original state and diagnostics are not
	performed. This is a required field.
	This field does not apply to bus diagnostics.

UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 86