A Summary of Commands

attach

attach

The attach command attaches a unit (card).

Synopsis

attach unit number [-i] [-n]

Description

The attach command is used to attach a card that has been “detached.” Use the attach command to allow the voice system to use a card that has just been replaced by hot swapping (that is, like-for-like replacement).

To put the card into service, use the restore command.

The parameters for the attach command are:

unit — This option identifies the unit; the choices are “channel” or “card.”

number — This option specifies the channel or card number, a range of channel or card numbers in the form m–n, or all for all channel or card numbers. Card numbers are in the form card#[.port#] where port# is a port of the card#. If port# is not given, all ports of the card specified are attached. If no card number or channel number is given, the system displays a syntax message.

UCS 1000 R4.2 Administration 585-313-507

Issue 3 April 2000 382