HP R4.2 immed, remove, min_delay, remove chan, remove card, display card, A Summary of Commands

A Summary of Commands remove

•immed — Removes a card or channel even if it is in use. Active calls are likely to be dropped when this option is specified. This option is necessary when the card or channel must be removed from service as soon as possible, and you are willing to terminate any active calls. You may also want to use this option to get control of a channel that is hung and not providing useful service.

•min_delay — Used to avoid waiting for channels to be granted. This option applies to remove chan and remove card requests that are removing network interface channels, for example, T1. This option specifies to minimize the delay in removing channels from service by not waiting for the channel to be granted. This option speeds up execution of the remove command, especially when a large number of channels are currently active.

When using this option, you must display the status of the channels with the display card command to determine when they are in the MANOOS state. This option can be used with or without the immed option and improves the response time in either case.

!CAUTION:

Removing a large number of channels from service with the min_delay option may cause momentary load problems on the switch.

UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 557