HP R4.2 1,2, all, trace, sleep, Note:, 1-4,FE, stop_vs, start_vs, /vs/data/irAPI.rc, TRACE_BUFFER_SIZE=X, A Summary of Commands

A Summary of Commands trace

•Use the sleep argument of the trace command to decrease the time that trace sleeps between reading the buffer. The default sleep time is 200 milliseconds.

•Increase the size of the trace buffer by adding or modifying the line TRACE_BUFFER_SIZE=X in the /vs/data/irAPI.rc file, where X is the number of messages that the trace buffer can hold. The default is 256. Increasing the value of X should reduce the chance of losing trace messages.

!CAUTION:

If you change the size system (stop_vs and

of the trace buffer, you must stop and restart the voice start_vs). Otherwise, you will not be able to run trace.

Examples

The following are examples of valid level lists and ranges:

1,2 Trace levels at 1 and 2

1-4,FETrace at levels 1, 2, 3, 4, and 20

all Trace at levels 1-32.

Note: Levels are not hierarchically inclusive. That is, level 3 does not imply that tracing at levels 1 and 2 also occurs, which could be achieved by using a range starting from 1. For example, 1-3for levels 1, 2, and 3.

UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 609