A Summary of Commands

attach

•-n— This option disables prompting from the system whether to wait until a conflict has been resolved (see the -ioption below) or to terminate the request to attach.

•-i— This option is used to enable secondary command registration. If T1 diagnostics are being run, this option allows the “attaching” of another card. If -iis used and another maintenance command is being run (remove, detach, attach, restore, or diagnose), the request to attach is blocked and a message is printed to the screen. If -iis not used and any maintenance command is being run, the request to attach is blocked and a message is printed to the screen.

If the command is permitted to run, it is determined if the command is in conflict with another command. A command is in conflict if the card or card associated with the command meets any of the following conditions:

~T1 card is being diagnosed

~An interdependency exists with the T1 card being diagnosed (for example, PRI)

If one of the above conflicts exist and -nis not used, the user is asked whether to wait until the conflict is resolved or to terminate the request. If T1 diagnostics are executing online tests and a conflict is detected, the attach command is blocked. If T1 diagnostics are executing offline tests and a conflict is detected, the user is asked whether to wait until the conflict is resolved or to terminate the request to attach.

UCS 1000 R4.2 Administration 585-313-507

Issue 3 April 2000 383