A Summary of Commands

spar

•-l— feature licensing

•-m— mean (average) data

•-p— peak data

•-t— time; used to specify how many minutes of data are summarized in each report line. The value must be 5 to 60, in increments of 5 (for example, 5, 10, or 15, and so on). The default is 20. To ensure valid data, the value for -t should be equal to or greater than the time increment specified for data collection by the spadc command.

•-f— file; used to specify an input data file. If no -f argument is given, the /var/adm/spa/mm-dd-yyyyfile is used for the current day. If the data file is not in /var/adm/spa, you must provide a full pathname to the input data file.

Examples

Note that values of “NA” in a report indicate that data was not available for that period, for example, if spadc data collection was not active, or if the system had to be rebooted. A value of zero indicates data collection was activated but no activity occurred.

spar -ap

This command creates a report showing peak percent usage for the entire board and for each of the different algorithms allocated to the board. A partial sample output is shown below.

UCS 1000 R4.2 Administration 585-313-507

Issue 3 April 2000 576